Sensor Cable M8 3-wire Straight 5m Long digital" The inductive Lidless Can Sensor

The inductive Lidless Can Sensor mounts near the seamer entrance on all Evolution Series and Fusion equipment and is used to detect the presence of a lidded can during operation

This air fitting is used on all Meheen Crowning Cylinders manufactured after 1/1/19

Recommended for general purpose air exhaust applications for pressures up to 125 psi (8

This bushing presses into the Bucking Block Fill Tube Guide on Fusion Counter Pressure systems and helps reduce friction between the block and the fill tube

Protection: IP66 / Enclosure Type 1

Sensor Cable M8 3-wire Straight 5m Long digital" The inductive Lidless Can SensorThis M8 3 wire connector cable is used with most Wild Goose Filling systems and has one molded female end and three wires on the other. For thread M8x1 A coded according to EN 61076 2 104 Pre assembled, molded female end. 5m (16. 4ft) Long Three wire pin